The Split Screen Van Club

Should have been this

Anyone been in touch with him,I cannot get any response from him by pm,I am waiting parts from him

I am also looking for one for 66 walk through at rear of van

Yes correct length for Dynamo ,I had two spare fuel pumps the Brazil one was knackered but VW one with inspection plate worked fine

Other fuel pump worked ok, did not realise spinning engine over on starter got push rod going up and down thanks to previous reply about 2 revs of engine equal one pump

Yup engine runs,I know the dizzy drive is not in proper location but solved by moving spark plug leads,will try and do pressure test as I have put another fuel pump on

Is this operated by cam on crankshaft or camshaft,on my rebuilt engine it does not seem to move,very strange,going to fit electric pump anyway but just curious

Hazard switch sold

I have hazard switch hella ,headlamp switch(VW) and 2 speed windscreen wiper switch that has been repaired and tested as working as have others,pm me for photos and prices as I have never mastered loading them on forum,ps hazard switch was fitted to my 66 bus I am assuming original and worked throug...

Looking for tee piece to fit from 10mm male into block and two 1/8 npt female out,quite tight for space under inlet manifold,any advice from someone who has done this,ta john

12v and regulator

I have this engine and it has a pict30/3 carburettor on it,it seems this was only available in USA ,very strange ,I wonder if this is still 1300,

Found it is non plunger type it uses

Got all parts now and a spare idle cut off valve with 55 idle jet

I have a recently rebuilt 1600 twin port engine no start with H code,also have gearbox H code ,I was wondering if it's possible to check gearbox if fitted to engine with clutch installed to check all forward and reverse gear without fitting reduction boxes etc